Stabilizer KNOTT KS30, bore 12/12mm

Stabilizer KNOTT KS30 for trailers with a maximum technically permissible weight of up to 3000 kg.

• Allows for safer driving at higher speeds, reduces trailer oscillation and vibration while driving.
• Stabilization of unwanted trailer swings is ensured by the ball pin retraction with friction segments.
• Stabilizing couplings are used exclusively dry (without the use of lubricants). ATTENTION!!! When using a stabilizing clutch on a lubricated ball stud, the friction segments will be degraded and the stabilizing effect will be significantly reduced.
• The KNOTT KS30 stabilizer joint is equipped with a correct connection indicator and a wear indicator for the ball joint and friction segments.
• When the coupling joint is fitted to the ball and the control lever is depressed, the friction segments are pressed against the ball stud with a force of up to 320 ^Nm2, effectively limiting trailer oscillation from the start of the journey.
• Can be mounted on 50 mm diameter ramp brake pull tubes.
• It is possible to purchase an original lock KNOTT for the KS25, KS30 and KS35 stabilizers. In combination with the security insert KNOTT, the stabilizer can be safely locked after disconnecting from the ball coupling pin (see related products below).
• The friction segments are replaceable and their wear rate can be monitored externally without the need for disassembly.
• Note: The use of stabilizing couplings is not suitable on balls attached to the hitch bracket with a single vertical bolt. The moment the friction segments grip the ball tightly and there is a slight sideways rotation during travel, the vertical bolt could be released from the bracket.