Axle for trailers GROMEX 2700 kg and 3500 kg, AL-KO Compact B 1200-6 (1350 kg)

Trailer axles GROMEX, AL-KO Compact B 1200-6 (1350 kg) a=1400 mm, bolt spacing 5x112

• is used for trailers GROMEX 2700 kg (2x1350 kg) and trailers GROMEX 3500 kg (3x1350 kg)

• Braked axle AL-KO for trailers, spring-loaded with rubber rods in hexagonal profile
• Thanks to the special shaping of the hexagonal axle and the pins of the arms, the rubber rods are not only compressed under load, but also roll down the wall of the hexagon. The result is a more comfortable suspension travel and higher damping compared to the conventional rubber sprung axle design with a square profile.
• High-quality suspension with high damping has a positive effect not only on ride comfort but also on driving safety
• The axle is equipped with wheel brake units AL-KO with automatic reversing. In reversing, when the brakes are applied by the towing vehicle's pressure, the wheel drive mechanism can detect the direction of the wheel's reverse rotation and release the brakes.
• High-quality double-row encapsulated ball bearings with permanent grease fill increase system reliability without higher maintenance requirements
• Axle arms allow easy mounting of the additional shock absorber spacer bracket after removing the plastic plugs
• The axle is equipped with a central bracket for two wire ropes. When using the axle as a front axle on a tandem trailer, a reduction of the cable brackets from 2 pcs to 4 pcs (249236) or (101111) is required and is not included.
• The axle is delivered without cable ducts and wheel bolts. You will find suitable cable guides and wheel bolts in the related products below. Select wheel bolts according to the bolt seating area specification of your wheels. Using a wheel bolt with an inappropriate seating surface may cause the bolt to loosen during driving. Always use new wheel bolts for a new axle. Do not lubricate the wheel bolts with oil or other lubricating grease.
• Recommended length of the quick-release cables for a single-axle trailer: 890/1086mm
• Recommended length of quick-release cables for tandem trailer: front axle - 890/1086 mm, rear axle up to 700 mm wheelbase - 1320/1516 mm, rear axle with wheelbase over 700 mm - 1320/1516 mm

• weight: 48kg
• Manufacturer: AL-KO
• arm angle: 25 °
• independent: no
• braked axle
• wheel mount: 112x5
• preparation for shock absorbers: yes
• maximum axle load: 1350kg
• wheel clearance (ET/IS): 30-33 mm
• width at mounting brackets: 1400mm
• width across drum seating area: 1850mm
• rubber suspension water resistance: standard
• wheel unit AL-KO type 2051 (pin diameter 34 mm)